
To configure the interface
The Test Automation Module can be connected to a printer, a plotter, or a
computer through the interface. The HP 54655A has an HP-IB interface
while the HP 54656A has an RS-232 interface.
1 Connect the Test Automation Module to a printer, plotter, or
computer through a suitable cable. Table 1 shows the HP part
numbers of the proper cables.
Table 1 Cable Part Numbers
Model Number Cable Function HP Part Number Description
HP 54655A (HP-IB) Oscilloscope to
Printer/Plotter
Controller
HP 10833A 1 meter (3.3 feet)
HP 10833B 2 meters (6.6 feet)
HP 10833C 4 meters (13.2 feet)
HP 10833D 0.5 meter (1.6 feet)
HP 54656A (RS-232) Oscilloscope to
Printer/Plotter
HP Vectra 25-pin
serial port
HP 13242G 5 meters (16.7 feet)
HP 17255M 1.2 meters (3.9 feet)
Oscilloscope to
IBM 25-pin
serial port
HP 92219J 5 meters (16.7 feet)
HP 17255D 1.2 meters (3.9 feet)
Oscilloscope to
9-pin serial port
HP 24542G 3 meters (9.9 feet)
See the section "RS-232 pin out" in chapter 5 for information on the pin outs
of the RS-232 cables.
Operating the Test Automation Module
To configure the interface
17
Comentarios a estos manuales