Agilent Technologies HP 54601B Guía de usuario descargar pdf (Pagina 33)

7 Turn the knob closest to the Cursors key to move the Y-coordinate of

the cursor to the voltage corresponding to the first point.

8 Press the Mark softkey to mark this point as the first point of a line

draw.

9 Turn the delay knob to move the X-coordinate of the cursor to the

time corresponding to the second point.

10 Turn the knob closest to the Cursors key to move the Y-coordinate of

the cursor to the voltage corresponding to the second point of the line.

11 Press the Connect softkey to draw the line.

12 Repeat procedures 5 through 11 for other lines.

Mask Editor operating hint

When you want to move the cursor to a particular location, it is essential to first

move the X-coordinate of the cursor then the Y-coordinate. Otherwise, the

movement of the Y-coordinate changes the position of a pixel at an undesired

location.

After you press the Connect softkey, the two points are connected by a straight

line. Points between the two end points are interpolated. However, if the

voltage of a particular point during interpolation violates the rule of the voltage

at the maximum limit ≥ voltage at the minimum limit, the voltage is set to the

same value as the other limit.

After you have marked the first point, pressing the Mark softkey again cancels

the previously marked point and starts the procedure over.

After you have connected the two points, pressing the Connect softkey again

will undo the connect operation.

Operating the Test Automation Module

To create a mask using straight lines

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 122 123

Sin comentarios

Agilent Technologies HP 54601B Guía de usuario Pagina 33