Agilent Technologies InfiniiVision 5000 Series Manual de servicio descargar pdf (Pagina 554)

100

101

554 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:SEQuence:TRIGger

(see page 750)

Command Syntax

:TRIGger:SEQuence:TRIGger <value>

<value> ::={PATTern2,ENTered | PATTern2,EXITed | EDGE2

| PATTern2,AND,EDGE2 | EDGE2,COUNt | EDGE2,COUNt,NREFind}

The :TRIGger:SEQuence:TRIGger command specifies the trigger stage of a

sequence trigger. The sequence commands set various search terms. After

all of these are found in sequence, the trigger condition itself is searched

for. This command accepts three program data parameters; you can use

NONE to fill out the parameter list (for example, "EDGE2,NONE,NONE").

PATTern2 is specified with the :TRIGger:SEQuence:PATTern command.

EDGE2 is specified with the :TRIGger:SEQuence:EDGE command. COUNt is

specified with the :TRIGger:SEQuence:COUNt command.

Query Syntax

:TRIGger:SEQuence:TRIGger?

The :TRIGger:SEQuence:TRIGger? query returns the trigger stage

specification for a sequence trigger. NONE is returned for unused

parameters.

Return Format

<trigger_value><NL>

<trigger_value> ::= {PATT2,ENT,NONE | PATT2,EXIT,NONE

| EDGE2,NONE,NONE | PATT2,AND,EDGE2

| EDGE2,COUN,NONE | EDGE2,COUN,NREF}

See Also • "Introduction to :TRIGger Commands" on page 440

• ":TRIGger:SEQuence:PATTern" on page 551

• ":TRIGger:SEQuence:EDGE" on page 549

• ":TRIGger:SEQuence:COUNt" on page 548

• ":TRIGger:SEQuence:FIND" on page 550

• ":TRIGger:SEQuence:RESet" on page 552

1 2 ... 549 550 551 552 553 554 555 556 557 558 559 ... 883 884

Comentarios a estos manuales

Sin comentarios

Agilent Technologies InfiniiVision 5000 Series Manual de servicio Pagina 554

Comentarios a estos manuales

Relacionado con productos y manuales para Multímetros Agilent Technologies InfiniiVision 5000 Series