Agilent Technologies 8935 Series Manual de usuario Pagina 233

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 352
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 232
Chapter 1 233
GPIB Command Dictionary
MEASure subsystem
:CDANalyzer:TRACe:TOFFset?
IS-95 Only mode. This command queries the timing in the 64 trace
points of the code domain analyzer. The measurement returns 64 values
(in seconds), one for each point.
Syntax
MEAS:CDAN:TRAC:TOFF?
Screen/field equivalent
MEAS:CDAN:TRAC:TOFF? does not correspond to any field on the
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
:CDANalyzer:TRACe:PERRor?
IS-95 Only mode. This command queries the phase in the 64 trace
points in the code domain analyzer. The measurement returns 64
values (in radians), one for each point.
Syntax
MEAS:CDAN:TRAC:PERR?
Screen/field equivalent
MEAS:CDAN:TRAC:PERR? does not correspond to any field on the
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
:CDANalyzer:TRACe:TPOWer?
IS-95 Only mode. This command queries the absolute (true) power in
each of the 64 Walsh channels, relative to the total power inside a 1.23
MHz bandwidth centered at the tune frequency. The measurement
returns 64 values (in dB), one for each point.
Syntax
MEAS:CDAN:TRAC:TPOW?
Screen/field equivalent
MEAS:CDAN:TRAC:TPOW? does not correspond to any field on the
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
Vista de pagina 232
1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 351 352

Comentarios a estos manuales

Sin comentarios