Agilent Technologies Infiniium 90000 Q-Series Especificaciones descargar pdf (Pagina 82)

Chapter 5: Replacing Assemblies

Removing and Replacing the Front Panel Assembly and Bottom Panel

Disconnect the Aux Out and Cal Out cables from both the front panel and the

backplane board. Pull straight back to remove the cables from the backplane

board. CAUTION: Be sure to pull straight back to avoid bending or breaking

the connection to the backplane board. When reconnecting, gently reinsert each

cable. You will hear a snap when it is fully seated.

Figure 5-25

Figure 5-26

The front panel is now disconnected.

Removing a RealEdge Assembly

If you are working on a 50 or 62 GHz model, it will have a RealEdge assembly.

The following steps show how to remove it. Be sure to remove the RealEdge

assembly before removing the front panel to avoid damaging the assembly.

1 Disconnect the two input cables from the RealEdge modules and from the

RealEdge modules to the RealEdge auxiliary module.

Figure 5-27

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 135 136

Sin comentarios

Agilent Technologies Infiniium 90000 Q-Series Especificaciones Pagina 82