Agilent Technologies 6634A Manual de usuario descargar pdf (Pagina 25)

Installing DUT Power Supplies

Installing DUT

Power Supplies

This section contains:

■ Introduction, 22

■ Installing the DUT Power Supply in a 307X System, 23

■ Installing the DUT Power Supply in a 317X System, 24

■ Installing the DUT Power Supply in a 327X System, 30

■ Installing the DUT Power Supplies in a 79000 System,

Introduction

This section describes how to install the DUT power

supply in the module or support bay. Proceed to the

section with instructions for a particular 3070 System.

To identify which model of system you are working on,

read the Common Testhead Product Number, which is

printed on the serial number label on the rear of the

cradle. Refer to Table 7 to relate the Common Testhead

product number to a model number.

The 79000 Functional Test System does not have a

common testhead number.

In the 307X, 317X and 327X systems, you must install a

radiation shield along with the DUT power supply. The

79000 system does not require the radiation shield.

When installing a high-voltage 6634A/B DUT power

supply in a 317X, you must install the shield

E4034-00601, shown in Figure 7 on page 23. When

installing a Faceless 6624A or a high-voltage 6634A/B

in a 327X, you must install the shield E3770-00601

(also shown in Figure 8 on page 25) unless one is

already installed.

Table 7 Common testhead product numbers

System Model Series I Testhead Series II Testhead Series III Testhead

307X (4-module Testhead) E1171A E4026A E9900A

317X (2-module Testhead) E1170A E4025A E9998A

327X (1-module Testhead) N/A E3770A E9997A

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 81 82

Sin comentarios

Agilent Technologies 6634A Manual de usuario Pagina 25