Agilent Technologies 6634A Manual de usuario descargar pdf (Pagina 33)

Installing DUT Power Supplies

Installing the DUT Power Supply in a 327X

System

These procedures describe how to install the DUT

power supply in a 327X testhead. If you are installing a

Faceless 6624A or an 6634A/B DUT power supply,

there are some additional procedures, as indicated

below. If it is not already present, a radiation shield

(E3770-00601) must be mounted onto the existing

support rails. Without this shield in place, the power

supply might radiate into nearby ASRU cards causing

measurement failures. This procedure is to be done only

by Agilent 3070 / 79000 service-trained customer

engineers.

1 Use a #2 Pozidriv screwdriver to remove the side

handles from both sides of the power supply.

Discard these parts.

2 Determine the location for the power supply using

Figure 11 on page 31.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 81 82

Sin comentarios

Agilent Technologies 6634A Manual de usuario Pagina 33