
© Agilent Technologies2000–2003 Agilent 3070 / 79000 DUT Power Supply Installation 28
Installing DUT Power Supplies
8 Slide the power supply into the testhead from the
front.
9 Using a #2 Pozidriv screwdriver, secure the power
supply rack-mount ears to the front of the testhead
using 4 each dress screws (0570-1366).
10 Replace the sheet metal cover (E1170-01208) on the
top of the testhead using the four T15 screws
removed in step 3 on page 24.
11 Using a 7/16-inch box or open-end wrench, replace
the hardware removed in step 3, securing the power
supply mounting bars in the testhead as shown in
Figure 10 on page 29.
Comentarios a estos manuales