Agilent Technologies HP 3325B Manual de instrucciones descargar pdf (Pagina 171)

Chapter 3 Replacing Assemblies

To Remove the Rear Terminals (Option 060)

Assembly-Level Service Guide 3-21

To Remove the Rear Terminals (Option 060)

1 Remove the cover.

See the section titled “To Remove the Cover” in this chapter.

2 Unsolder the lead-end of the cables from their appropriate ground and input

pads on the A1 Motherboard Assembly (J16, J17) as shown in Figure 3-13.

For the Agilent 53131A/132A unsolder the rear chassis INPUTS 1 cable to J16 and

INPUTS 2 to J17.

For the Agilent 53181A unsolder the rear chassis INPUTS 1 cable to J17.

NOTE If there are upper or lower shields installed on A1 Motherboard Assembly, cut them

out and then remove Option 060 Rear Terminal cable(s). Replace the front bezel with

the metalized version (53131-40001).

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 251 252

Sin comentarios

Agilent Technologies HP 3325B Manual de instrucciones Pagina 171