Agilent Technologies 2000 X-Series Manual de servicio descargar pdf (Pagina 429)

:SAVE Commands 24

Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 429

:SAVE:IMAGe[:STARt]

(see page 790)

Command Syntax

:SAVE:IMAGe[:STARt] [<file_name>]

<file_name> ::= quoted ASCII string

The :SAVE:IMAGe[:STARt] command saves an image.

See Also • "Introduction to :SAVE Commands" on page 426

• ":SAVE:IMAGe:FACTors" on page 430

• ":SAVE:IMAGe:FORMat" on page 431

• ":SAVE:IMAGe:INKSaver" on page 432

• ":SAVE:IMAGe:PALette" on page 433

• ":SAVE:FILename" on page 428

Be sure to set the :SAVE:IMAGe:FORMat before saving an image. If the format is NONE, the

save image command will not succeed.

If a file extension is provided as part of a specified <file_name>, and it does not match the

extension expected by the format specified in :SAVE:IMAGe:FORMat, the format will be

changed if the extension is a valid image file extension.

If the extension ".bmp" is used and the current :SAVE:IMAGe:FORMat is not BMP or BMP8,

the format will be changed to BMP.

Sin comentarios

Agilent Technologies 2000 X-Series Manual de servicio Pagina 429