Agilent Technologies PSG Manual de instrucciones descargar pdf (Pagina 269)

100

101

Command Reference

List/Sweep subsystem ([:SOURce])

Chapter 4 255

:LIST:DWELl

Supported All

[:SOURce]:LIST:DWELl <val>{,<val>}

[:SOURce]:LIST:DWELl?

This command sets the dwell time for the current list sweep points.

The variable <val> is measured in units of seconds with a 0.001 resolution.

NOTE The dwell time (<val>) does not begin until the signal generator has

settled for the current frequency and/or amplitude change. When the

signal generator has settled, a trigger signal is transmitted through the

rear panel SOURCE SETTLED OUTPUT connector.

*RST

Ν/Α

Range 0.001

−

Key Entry N/A

Remarks Dwell time is used when IMMediate is the trigger source. Refer to

“:LIST:TRIGger:SOURce” on page 259 for the trigger setting.

The dwell time is the amount of time the sweep is guaranteed to pause

after setting the frequency and/or power for the current point.

The setting enabled by this command is not affected by signal

generator power-on, preset, or *RST.

:LIST:DWELl:POINts

Supported All

[:SOURce]:LIST:DWELl:POINts?

This command queries the signal generator for the number of dwell points in the current

list sweep file.

*RST Ν/Α

Range Ν/Α

Key Entry N/A

Remarks N/A

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 361 362

Comentarios a estos manuales

Sin comentarios

Agilent Technologies PSG Manual de instrucciones Pagina 269

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores De Poder Agilent Technologies PSG