Agilent Technologies PSG Manual de instrucciones descargar pdf (Pagina 317)

Command Reference

SCPI Command Compatibility

Chapter 4 303

SHKZ Write to IO not supported

SHHZ Read from IO not supported

SL0 Power slope off POWer:SLOPe:STATe OFF|0

SL1 Power slope on POWer:SLOPe:STATe ON|1

POWer:SLOPe <value>[DB/freqsuffix]

SM Sweep, manual not supported

SN Steps, maximum SWEep:POINts <val>

SP Set power step size POWer[:LEVel][:Immediate][:AMPLitude]:STEP[:

INCREment] <val>

ST Sweep time not supported

SV Save instrument state *SAV <reg_num>[,<seq_num>]

SW Swap NA channels not supported

T1 Trigger, free run not supported

T1 b Test GPIB not supported

T2 Trigger, line not supported

T3 Trigger, external not supported

TL Time line not supported

TS Take sweep not supported

UP Up step see Table 4-6 on page 304

a. PSG family uses external detector coupling factor instead of reference voltage.

b. PSG family uses AM2 path and EXT 1 input.

c. Same as DU0 on page 297 for PSG family.

d. PSG family uses FM2 path and EXT 2 input.

e. 8340B/41B: sensitivity values

≤

1 MHz are set to 1 MHz;

sensitivity values >1 MHz are set to 10 MHz

PSG Family: sensitivity is set to specified value.

f. Refer to the “:SYSTem:IDN” command on page 294 to customize the string returned by *IDN? or OI

g. RB command emulates knob motion on PSG family.

h. Saved under seq_num = 0, and note that RC 0 (recall last front panel settings) is not supported.

i. Same as DU1 on page 297 for PSG family.

j. Same as AT on page 296 for PSG family.

Table 4-5 8340B/41B Programming Codes and Equivalent SCPI Sequences

Code Description Equivalent SCPI Command Sequence

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 361 362

Sin comentarios

Agilent Technologies PSG Manual de instrucciones Pagina 317