Agilent Technologies Ininiium 9000 Especificaciones descargar pdf (Pagina 124)

Chapter 6: Replacing Assemblies

To remove and replace the front panel bezzle, front panel keyboard, touchscreen, and Autoprobe

board

124

Figure 6-16

There is a cable you will need to disconnect from the back of the breakaway board (see Figure

6-17).

Figure 6-17

To remove the Autoprobe board, remove the two T10 screws and then slide the board to the

right to disengage the two latches on either side of the board (see Figure 6-18). When

reattaching the Autoprobe board, do not fully tighten the two T10 screws until you have

reattached the front panel keyboard to the oscilloscope and attached it to the Autoprobe

Touchscreen

Push breakaway board

straight out away from

the touchscreen and

then lift up

These are two of the latches you are disengaging

when you pull the board straight away from the

touchscreen

This is the edge that

breaks away from the

front panel keyboard

(they come attached

together)

Disconnect

this cable

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 165 166

Sin comentarios

Agilent Technologies Ininiium 9000 Especificaciones Pagina 124