Agilent Technologies Ininiium 9000 Especificaciones Pagina 137

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 166
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 136
Chapter 6: Replacing Assemblies
To remove and replace the acquisition board assembly
137
Figure 6-36
Figure 6-37
3
Place the oscilloscope on its face (make sure the front panel cover is installed) and lift the piece
of sheet metal up to access the acquisition board (as shown in Figure 6-38).
Then remove this screw
This is the lower
right hand side of
the oscilloscope
(as viewed from
the rear of the
oscilloscope).
Finally, remove these
two screws
These are the BNCs
located in the upper left
hand corner of the
oscilloscope’s rear panel
(as viewed from the rear)
Vista de pagina 136
1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 165 166

Comentarios a estos manuales

Sin comentarios