Agilent Technologies Ininiium 9000 Especificaciones descargar pdf (Pagina 127)

Chapter 6: Replacing Assemblies

To remove and replace the front panel bezzle, front panel keyboard, touchscreen, and Autoprobe board

127

Remove the four T10 screws that attach the touchscreen to the sheet metal (there are two on

each side of the touchscreen - right and left). See Figure 6-22. When reattaching these screws,

tighten to 5 in-lbs.

Figure 6-22

Final Reassembly Note: When performing these procedures in reverse to reassemble the

instrument, be sure to fully press in on all edges (inner and outer edges) when you place the

front bezzle back on the oscilloscope.

19 Final Reassembly Note: Before reassembling the front chassis, be sure all cables are pulled

through their appropriate openings and/or reattached to any boards located on the back side of

the front chassis. Once you close the chassis, it can be difficult to reach into these small holes

and pull the cables through.

20 Final Reassembly Note: Before placing the rear cover back on the oscilloscope, be sure to

reattach the removable hard drive cover.

Figure 6-23

Remove these two screws and the

two on the other side of the

touchscreen

This board should already

be removed so you can pull the

touchscreen cable through from

the other side of the sheet metal

Removable

hard drive

cover

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 165 166

Sin comentarios

Agilent Technologies Ininiium 9000 Especificaciones Pagina 127