Agilent Technologies Ininiium 9000 Especificaciones Pagina 135

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 166
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 134
Chapter 6: Replacing Assemblies
To remove and replace the acquisition board assembly
135
To remove and replace the acquisition board assembly
Use this procedure to remove and replace the acquisition board assembly. When necessary, refer to other
removal procedures. The graphics in this chapter are representative of the oscilloscope at the time of
this printing. Your unit may look different.
1
Disconnect the power cable and remove the rear oscilloscope cover as described in previous
sections.
2 Remove the screws show in Figure 6-34, Figure 6-35, Figure 6-36, and Figure 6-37 to remove
the sheet metal separating the motherboard compartment from the acquisition board
compartment.
Vista de pagina 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 165 166

Comentarios a estos manuales

Sin comentarios