Agilent Technologies Ininiium 9000 Especificaciones descargar pdf (Pagina 138)

Chapter 6: Replacing Assemblies

To remove and replace the acquisition board assembly

138

Figure 6-38

Disconnect the SATA cables (see Figure 6-38) and then remove the air diverted that covers

the acquisition board (see Figure 6-38).

5 Place the oscilloscope so that it is no longer resting on its front panel, but is instead sitting on

its feet (in its normal operating orientation). Then remove the screws located next to each BNC

input on the front panel (Figure 6-39).

Figure 6-39

Then place the oscilloscope so it is once again sitting on its front side (use the front panel

cover), disconnect any remaining cables connected to the acquisition board, remove all screws

This is the air diverter that is above the

acquisition board

This is the upper part that

you lift up on (the

motherboard is located on

the other side of this piece

of sheet metal)

These are the SATA

cables that need

removed before you

remove the air diverters

These are the four screws

by the front panel BNCs that

need removed in order to

remove the acquisition

board.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 165 166

Sin comentarios

Agilent Technologies Ininiium 9000 Especificaciones Pagina 138