Agilent Technologies Ininiium 9000 Especificaciones descargar pdf (Pagina 144)

Chapter 6: Replacing Assemblies

To remove and replace the hard disk drive

144

To remove and replace the hard disk drive

Use this procedure to remove and replace the hard disk drive. When necessary, refer to other removal

procedures. The graphics in this chapter are representative of the oscilloscope at the time of this printing.

Your unit may look different.

Disconnect the power cable and remove the rear cover.

2 Open up the acquisition chamber by removing the sheet metal that separates the motherboard

section from the acquisition board section (refer to the Acquisition Assembly Removal section

for instructions on how to do this).

3 The hard drive is attached to the under side of this piece of sheet metal.

4 Disconnect the SATA cables from the hard disk drive, remove the screws attaching it to the

sheet metal, and remove it from the oscilloscope.

Figure 6-42

Hard disk drive

These are the SATA cables you need to

disconnect from the hard disk drive

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 165 166

Sin comentarios

Agilent Technologies Ininiium 9000 Especificaciones Pagina 144