Agilent Technologies Ininiium 9000 Especificaciones descargar pdf (Pagina 130)

Chapter 6: Replacing Assemblies

To remove and replace the touch screen controller board

130

To remove and replace the touch screen controller board

Use this procedure to disassemble and reassemble the touch screen controller board. When necessary,

refer to other removal procedures. The graphics in this chapter are representative of the oscilloscope at

the time of this printing. Your unit may look different.

Disconnect the power cable and remove the handle and rear cover.

2 Remove the front panel bezzle as described in a previous section.

3 Open up the front chassis by removing the four T15 screws (two are located on the right side

of the oscilloscope and two are located on the left side). See Figure 6-27.

Figure 6-27

Pull the front panel chassis away from the main chassis as shown in Figure 6-28.

This is the upper right side

screw that needs removed.

There is also one below it and

then two screws on the

left side of the oscilloscope

in the same relative locations

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 165 166

Sin comentarios

Agilent Technologies Ininiium 9000 Especificaciones Pagina 130