Agilent Technologies 1100 Series Guía de instalación descargar pdf (Pagina 175)

1100 LC Modules Control Manual - 175 - 03-914947-30:Rev.6

During the test, a theoretical analog signal of approximately 52

mV with a square wave of 10µV and a frequency of 1 cycle / 48

seconds is applied to the digital-analog-converter (DAC).

The DAC signal must be plotted on an integrator at least 5

minutes in order to measure the amplitude and the peak-to-peak

noise of the signal. The results are not directly provided by the

Instrument Maintenance Software but by the integrator.

The following performed stages are displayed on screen and

also in the maintenance audit trail:

For analyzing the test results, refer to the detector operating

manual.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 183 184

Sin comentarios

Agilent Technologies 1100 Series Guía de instalación Pagina 175