Agilent Technologies 1100 Series Guía de instalación descargar pdf (Pagina 178)

1100 LC Modules Control Manual - 178 - 03-914947-30:Rev.6

Appendix

GPIB Addresses

The 1100 Master module connected to Galaxie with the GPIB

cable must have a unique address between 0 and 31. Usually 21

is reserved for IEEE488 controller (GPIB card or 800 MIB with

GPIB card).

The address is set with an 8 bit switch located on the rear panel

of modules. Changing the position of these switches must be

done with module switched-off.

The following table shows the switch positions for each GPIB

address:

Address Sw4 Sw5 Sw6 Sw7 Sw8

0 Down Down Down Down Down

1 Down Down Down Down Up

2 Down Down Down Up Down

3 Down Down Down Up Up

4 Down Down Up Down Down

5 Down Down Up Down Up

6 Down Down Up Up Down

7 Down Down Up Up Up

8 Down Up Down Down Down

9 Down Up Down Down Up

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 184

Sin comentarios

Agilent Technologies 1100 Series Guía de instalación Pagina 178