Agilent Technologies InfiniiVision 6000 Series Manual de servicio Pagina 224

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 934
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 223
224 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:CALibrate:STARt
(see page 798)
Command Syntax
:CALibrate:STARt
The CALibrate:STARt command starts the user calibration procedure.
See Also "Introduction to :CALibrate Commands" on page 219
":CALibrate:SWITch" on page 226
NOTE
Before starting the user calibration procedure, you must set the rear panel CALIBRATION
switch to UNPROTECTED, and you must connect BNC cables from the TRIG OUT connector
to the analog channel inputs. See the User's Guide for details.
Vista de pagina 223
1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 933 934

Comentarios a estos manuales

Sin comentarios