Agilent Technologies InfiniiVision 6000 Series Manual de servicio descargar pdf (Pagina 546)

100

101

546 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:I2S:RANGe

(see page 798)

Command Syntax

:TRIGger:I2S:RANGe <upper>,<lower>

<upper> ::= 32-bit integer in signed decimal, <nondecimal>,

or <string>

<lower> ::= 32-bit integer in signed decimal, <nondecimal>

or <string>

<nondecimal> ::= #Hnn...n where n ::= {0,..,9 | A,..,F}

for hexadecimal

<nondecimal> ::= #Bnn...n where n ::= {0 | 1} for binary

<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F} for hexadecimal

The :TRIGger:I2S:RANGe command sets the upper and lower range

boundaries used by the INRange, OUTRange, INCReasing, and DECReasing

trigger conditions. You can enter the parameters in any order — the

smaller value becomes the <lower> and the larger value becomes the

<upper>.

Note that for INCReasing and DECReasing, the <upper> and <lower> values

correspond to the "Armed" and "Trigger" softkeys.

Query Syntax

:TRIGger:I2S:RANGe?

The :TRIGger:I2S:RANGe? query returns the currently set upper and lower

range boundaries.

Return Format

<upper> ::= 32-bit integer in signed decimal, <nondecimal>,

or <string>

<lower> ::= 32-bit integer in signed decimal, <nondecimal>

or <string>

<nondecimal> ::= #Hnn...n where n ::= {0,..,9 | A,..,F}

for hexadecimal

<nondecimal> ::= #Bnn...n where n ::= {0 | 1} for binary

<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F} for hexadecimal

See Also • "Introduction to :TRIGger Commands" on page 479

NOTE

The length of the <upper> and <lower> values is determined by the :TRIGger:I2S:RWIDth

and :TRIGger:I2S:TWIDth commands. When the receiver word size is less than the

transmitter word size, the length is equal to the receiver word size. When the receiver word

size is greater than the transmitter word size, the length is equal to the transmitter word

size.

1 2 ... 541 542 543 544 545 546 547 548 549 550 551 ... 933 934

Comentarios a estos manuales

Sin comentarios

Agilent Technologies InfiniiVision 6000 Series Manual de servicio Pagina 546

Comentarios a estos manuales

Relacionado con productos y manuales para Multímetros Agilent Technologies InfiniiVision 6000 Series