Agilent Technologies InfiniiVision 6000 Series Manual de servicio Pagina 751

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 934
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 750
Obsolete and Discontinued Commands 7
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 751
:TRIGger:CAN:SIGNal:DEFinition
(see page 798)
Command Syntax
:TRIGger:CAN:SIGNal:DEFinition <value>
<value> ::= {CANH | CANL | RX | TX | DIFFerential}
The :TRIGger:CAN:SIGNal:DEFinition command sets the CAN signal type
when :TRIGger:CAN:TRIGger is set to SOF (start of frame). These signals
can be set to:
Dominant high signal:
CANH — the actual CAN_H differential bus signal.
Dominant low signals:
CANL — the actual CAN_L differential bus signal.
RX — the Receive signal from the CAN bus transceiver.
TX — the Transmit signal to the CAN bus transceiver.
DIFFerential — the CAN differential bus signal connected to an analog
source channel using a differential probe.
Query Syntax
:TRIGger:CAN:SIGNal:DEFinition?
The :TRIGger:CAN:SIGNal:DEFinition? query returns the current CAN
signal type.
Return Format
<value><NL>
<value> ::= DIFF
See Also "Introduction to :TRIGger Commands" on page 479
":TRIGger:MODE" on page 485
":TRIGger:CAN:SIGNal:BAUDrate" on page 497
":TRIGger:CAN:SOURce" on page 498
":TRIGger:CAN:TRIGger" on page 499
NOTE
With InfiniiVision 6000 Series oscilloscope software version 3.50 or greater, this command
is available, but the only legal value is DIFF.
Vista de pagina 750
1 2 ... 746 747 748 749 750 751 752 753 754 755 756 ... 933 934

Comentarios a estos manuales

Sin comentarios